Do you get a following error? or is it just off? encoders or resolvers? On 4/12/2011 9:34 AM, Stuart Stevenson wrote: > Gentlemen, > I was just made aware of a recurring problem with the Cinci and the Enshu. > I have heard nothing about the Dahlih. > The Enshu is running 2.5.0-pre and Touchy interface. > The Cinci is running 2.5.0-pre and Axis interface. > Yesterday the Enshu lost Y position during a program run. The Cinci has > done this previously but that was before the latest update to 10.04 and > 2.5.0-pre. I did not report anything when the Cinci lost position because I > could not be certain the problem was not mechanical. I am not CERTAIN the > problem is not mechanical now but on two machines I have the same symptom. > This leads me to want to report this. > On the Enshu the Y position was incorrect by approximately .400 inch in > the middle of the tool motion. Some correct cuts were made and then the tool > plunged into the part in an incorrect position. Sending the machine to Y0 > showed the misposition in the program zero. Homing the machine corrected the > error. > The same error repeated a little later yesterday during the run of a > different part program. This time the error was in the opposite direction of > the previous error. Again, homing the machine corrected the error. > We have only seen this happen on the Y axis on both machines. > Questions will be investigated/answered to the best of my ability. > thanks > Stuart >
------------------------------------------------------------------------------ Forrester Wave Report - Recovery time is now measured in hours and minutes not days. Key insights are discussed in the 2010 Forrester Wave Report as part of an in-depth evaluation of disaster recovery service providers. Forrester found the best-in-class provider in terms of services and vision. Read this report now! http://p.sf.net/sfu/ibm-webcastpromo _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
