Yes everything at our shop is wired off 3 phase. But our box has a nuetral. So it goes from leg to nuetral. However my machine only has 4 lines - the 3 legs of power and an earth ground. So i guess my question is do i need the nuetral?
Sent from my iPod On Nov 10, 2011, at 8:59 PM, Eric Keller <[email protected]> wrote: > the lights and most outlets here at work are single phase wired off of 3 > phase. > > On Thu, Nov 10, 2011 at 9:50 PM, Brian May <[email protected]> wrote: > >> This is probably an easy question for alot af the people on the list. >> >> I have 3 phase power going to my vfd on my machine. I want to the use >> that same power to power all the 120 single phase components. (the dc power >> supply for the steppers and varios other motors. ). This way i only need 1 >> plug >> >> I have been reading and people say i can go from 1 leg to a nuetral or leg >> to leg. I do not have a nuetral line so my question is will it be ok to go >> from leg to leg for the 120 single phase? Or is there some other component >> i need? >> >> Thanks >> Brian >> >> Sent from my iPod >> >> ------------------------------------------------------------------------------ >> RSA(R) Conference 2012 >> Save $700 by Nov 18 >> Register now >> http://p.sf.net/sfu/rsa-sfdev2dev1 >> _______________________________________________ >> Emc-users mailing list >> [email protected] >> https://lists.sourceforge.net/lists/listinfo/emc-users >> > ------------------------------------------------------------------------------ > RSA(R) Conference 2012 > Save $700 by Nov 18 > Register now > http://p.sf.net/sfu/rsa-sfdev2dev1 > _______________________________________________ > Emc-users mailing list > [email protected] > https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ RSA(R) Conference 2012 Save $700 by Nov 18 Register now http://p.sf.net/sfu/rsa-sfdev2dev1 _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
