Interesting. Just out of curiosity, how is orient accomplished on that macine? Is it completely electronic or mechanical or what? Looks like it works quite well man Congrats!
Pete On Mon, Jun 15, 2015 at 10:17 AM, Chris Kelley <tensait...@gmail.com> wrote: > Pete, > > The fingers on the end of the drawbar that grab the retention knob (pull > stud) are spring loaded and hold the tool even when the drawbar is pushed > down. The arm just pulls down enough to overcome the spring force to remove > the tool and up hard enough for the tool to snap into place. Honestly, I > was surprised that more drawbars don't work this way, but considering > everyone's reaction, I guess few do. > > Kirk, > > I'm going to guess lack of lubrication. One of the lower flexible oil lines > was age-hardened and broke. So until it (and the Bijur compression > fittings) comes in, the pump is disabled. Obviously, aside from short test > runs we won't be running the machine until that is rectified. > > On Mon, Jun 15, 2015 at 9:01 AM, Kirk Wallace <kwall...@wallacecompany.com > > > wrote: > > > On 06/15/2015 06:45 AM, Chris Kelley wrote: > > > Well, we had to make a little circuit board to convert the Fanuc > spindle > > > analog pulse generator signals to digital quadrature pulses and I > mounted > > > an optical sensor to read a flag on the spindle to make an index pulse. > > > > > > Anyway, the machine now rigid taps. > > > > Bravo. > > > > Any ideas on what is making the squeaking noise as Z descends? > > > > > > -- > > Kirk Wallace > > http://www.wallacecompany.com/machine_shop/ > > http://www.wallacecompany.com/E45/ > > > > > > > ------------------------------------------------------------------------------ > > _______________________________________________ > > Emc-users mailing list > > Emc-users@lists.sourceforge.net > > https://lists.sourceforge.net/lists/listinfo/emc-users > > > > ------------------------------------------------------------------------------ > _______________________________________________ > Emc-users mailing list > Emc-users@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/emc-users > -- Pete Matos A and N Precision and Fabrication Maryville, Tennessee 865-236-8996 ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
