On Saturday 17 October 2015 23:21:56 Todd Zuercher wrote: > Ahh, the "better" mouse trap. You can still get the old fashioned > wooden ones. (pretty sure Dollar General usually has them). I like > some of the newer wooden ones that have the plastic trigger pad. They > are very sensitive sometimes almost too sensitive. (go off when you > set them down.)
I hadn't considered the dollar store. We've a couple of those, out in the very low rent districts. Thanks for the reminder. > ----- Original Message ----- > From: "Gene Heskett" <ghesk...@wdtv.com> > To: emc-users@lists.sourceforge.net > Sent: Saturday, October 17, 2015 10:47:43 PM > Subject: Re: [Emc-users] using tool table offsets with G41 or 42 > > On Saturday 17 October 2015 00:21:32 Gene Heskett wrote: > > [...] > > > If tool compensation can really be made to work, it would simplicate > > at least 100 LOC out of this program. Already has, but I'm now > > adding more stuff to make sure there is turn around room at the ends > > of the cut sweeps. But tomorrow is another day. I am pleased with > > todays progress. > > This was that tommorrow. I kept getting closer & closer, but I've > come to 3 conclusions. > > 1. I need a roundover tool with a slightly larger radii, these are > 1/8", bought because the 1/4" tool leaves a 1/8" radius cut at an > inside corner, and I need perhaps a 5/32 or even a 3/16, but those > seem to be made of pure unobtainium. > > 2. This tool, at 2500 revs, if it does have a sharp point, needs to be > fed quite a bit slower than 20 IPM, the tip is just rolling on the > wood, leaving a line of whiskers to clean off. So tommorrow I'll add > a roundover feed rate thats about 1/8th the 1/4" tools 20 ipm feed > rate to see if that will result in a cleaner cut. > > 3. I need to add a radius move at the inner end of the fingers > pockets, a bit over and above what the tool comp does, its squaring up > that inside corner too much. That isn't hurting anything but it does > look funkity when the joints are brought together. And THAT will be > fun, NOT. > > 4. I had a mouse run into the garage a couple days ago while I was > doing some house cleaning & trash bagging. So I went to Shop & Save & > got the only re-usable mouse traps they had, the other choices being > sticky pads or DeCon. Made out of thin galvanized steel these days, a > very very poor design. I've been bending parts around to make them > more sensitive, but so far all I am doing is furnishing a 2 location > daily buffet of peanut butter, which its repeatedly cleaning off the > trip pans because they are so damned hard to trip. The basic problem > is that the wire holding the spring loaded bail open, has its anchor > point about 3x farther away from the bail wire than the old style > wooden trap, so the leverage it puts on the trip wire is sufficient to > actually lift the pan back into position as long as its not standing > on the pan with all 4 feet. > > I take it they were designed to be a buffet table by the humane > society, not to kill mice. :( > > Cheers, Gene Heskett Cheers, Gene Heskett -- "There are four boxes to be used in defense of liberty: soap, ballot, jury, and ammo. Please use in that order." -Ed Howdershelt (Author) Genes Web page <http://geneslinuxbox.net:6309/gene> ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users