It was a while ago that I upgraded things. So I can't say for sure what the order of events were. But I was running 2.7pre on this machine as soon as it came out and I know I did not update the firmwares right away, and ran for a while just ignoring the notice to update them. I don't think during that time I had the problem with the smart serial errors until after I updated the firmwares, also about that same time I changed my config to run at a higher rate, moving the hm2 read/rights and velocity loop for the servos to a floating point base thread. I've been blaming the ss communication problems on the base thread speed being borderline too fast. So for me the real question is what is the source of the problem, is it that something in 2.7 is more sensitive to errors than before, is something in the new firmware making it more sensitive, something in 2.7 or the firmware causing more errors than before, or is it my thread speed. I don't want to blame electronic interference becaus e it worked before for years and none of that changed. But in a way that probably is the real source, because it is when powering on the machine(F2) after an e-stop when I most often see this error (about half the time). I'll check into these parameters and see if I can tame it down to acceptable level.
----- Original Message ----- From: "andy pugh" <[email protected]> To: "Enhanced Machine Controller (EMC)" <[email protected]> Sent: Tuesday, December 8, 2015 8:44:11 PM Subject: Re: [Emc-users] linuxcnc 2.7.3 - mesa 7i77 update On 9 December 2015 at 01:21, Stephen Dubovsky <[email protected]> wrote: > How to set dec? And what was it in prior versions? You set it like any other HAL parameter. Details are there if you look at man sserial setp hm2_5i24.0.sserial.port-N.fault-inc 0 Will disable all smart-serial fault reporting. Naturally you will have to use parameters that actually exist in your configuration. The values haven't changed, but something else has, I am not sure what. -- atp If you can't fix it, you don't own it. http://www.ifixit.com/Manifesto ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
