On 25 June 2017 at 00:20, dave <dengv...@charter.net> wrote: > can't quite figure out how I can be in the middle of the bed .... with a > small part and still > get limit violations >
Is this actual limit-switch trips. or warnings that the G-code exceeds machine limits? The first is probably electrical noise. I seem to always end up with a software low-pass on those signals, just because false-trips are so annoying and a couple of mS delay in responding to a limit switch isn't that critical. If it is the second, then you might need to have a look at your coordinate system offsets. http://wiki.linuxcnc.org/cgi-bin/wiki.pl?CoordinateSystems#So_if_you_re_lost_what_should_you_do -- atp "A motorcycle is a bicycle with a pandemonium attachment and is designed for the especial use of mechanical geniuses, daredevils and lunatics." — George Fitch, Atlanta Constitution Newspaper, 1916 ------------------------------------------------------------------------------ Check out the vibrant tech community on one of the world's most engaging tech sites, Slashdot.org! http://sdm.link/slashdot _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users