On 03/20/2020 08:46 AM, Leonardo Marsaglia wrote:
I re-checked and I have the same values for speed and acceleration in
joints and axes. The thing that was limiting my velocity was the
OFFSET_AV_RATIO entry. I had it near 0.9 and once I homed the axis started
to cause the effect. Reducing it to 0.1 solved the problem. If I don't
remember wrong this happened with and without the eoffset enabled. I'll
check it again in a few moments.
ARRGH! Just when I think I finally understand LinuxCNC,
they add YET another complexity!
I'd never even HEARD of this.
Jon
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
