On Friday 20 March 2020 11:19:33 Jon Elson wrote:

> On 03/20/2020 08:46 AM, Leonardo Marsaglia wrote:
> > I re-checked and I have the same values for speed and acceleration
> > in joints and axes. The thing that was limiting my velocity was the
> > OFFSET_AV_RATIO entry. I had it near 0.9 and once I homed the axis
> > started to cause the effect. Reducing it to 0.1 solved the problem.
> > If I don't remember wrong this happened with and without the eoffset
> > enabled. I'll check it again in a few moments.
>
> ARRGH!  Just when I think I finally understand LinuxCNC,
> they add YET another complexity!
> I'd never even HEARD of this.
>
> Jon
>
You're confused?, I'm plumb bumfuzzled. Is the OP even talking about 
LinuxCNC?  And the last I saw Leonardo mention where he was, he was in 
northern Europe, now he's in Agentina? Somethings not calculating.

Cheers, Gene Heskett
-- 
"There are four boxes to be used in defense of liberty:
 soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
If we desire respect for the law, we must first make the law respectable.
 - Louis D. Brandeis
Genes Web page <http://geneslinuxbox.net:6309/gene>


_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users

Reply via email to