Brand new setup using stepconf. if I spin the spindle encoder quickly
by hand I get: rtapi_app: caught signal 8 - dumping core
Even if the machine is still in e-stop. Simple config using stepconf
LINUXCNC - 2.9.0~pre0
All default settings other than manual edit of LPT base address and
changed setp encoder.0.position-scale 4000.000000 Default is like
100 vs 4000
Any ideas what causes this error?
https://forum.linuxcnc.org/media/kunena/attachments/1324/simple.ini
https://forum.linuxcnc.org/media/kunena/attachments/1324/simple.hal
The only mention of a similar error:
forum.linuxcnc.org/24-hal-components/358...hercat-lcec?start=10
_______________________________________________
Emc-users mailing list
Emc-users@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/emc-users
