Er 100 minus 2 (the holes you cut metal between is 98? ________________________________ From: Ed <ate...@mwt.net> Sent: Sunday, September 18, 2022 4:53 PM To: emc-users@lists.sourceforge.net <emc-users@lists.sourceforge.net> Subject: Re: [Emc-users] missing tooth index questions..
On 9/18/22 3:50 PM, Sam Sokolik wrote: > I have a optical encoder from a mouse running on an emco encoder wheel (100 > holes). I cut out the metal between 2 holes. I think that would be > considered one missing tooth... I have the encoder scale set to 100 and > the missing tooth set to 1 > > I have a little comp that sets the index enable to true whenever it is > false. > > Looking at the halscope screen shot - it only counts to 98.. I would think > it would count from 0 to 99. You can see the gap is seen - but I think > there should be an extra count in there.. Am I missing something? 0-99=100 inclusive. Ed. _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users