On Friday 30 November 2001 12:12 pm, William Bouterse wrote:
> This could of course be strickly "bad timing"
> However ;
> generic ne 200 clone card has worked through LM6.x,7.x's-
> 8.0freq now it doesn't..Worked before install of LM8.1....
>
> card is recognized by install and even autoprobe works
> without having to manually configure specs.
>  (this is a "client" machine on small network)
>
> ifconfig shows eth0 active with proper init address
> The card can be "ping'd" internally and localhoast too .
> Cannot ping outside machine.
> Can ping Bcast #
>
> route shouws exact Ip routing as another working machine.....
>
> I have used draknet as well as manually altering
> the config files....
>
> I have taken out this card and put it back in.
>
> Before I actually replace it I was wondering if there was something
> obvious I was missing here.?
>
> Thanks

Hmmm

What IRQ is it on?

What does

cat /etc/sysconfig/network*

say?

How about 

cat /etc/resolv.conf

and 

route

Civileme

Want to buy your Pack or Services from MandrakeSoft? 
Go to http://www.mandrakestore.com

Reply via email to