So I have settled on replacing the hard drive with a SSD. But I have two more questions.
1) I see on the cluepon link that they are using a 8gb drive. RE-400 comes with a 20 gig drive. Will a 8gb be fine, or should I get something of similar size to the factory size. 2) I did have a CF card in the router, is it normal/default behavior for it to reboot the router upon disk failure? Brendan On 8/14/09 12:50 PM, "Jonas Frey" <j...@probe-networks.de> wrote: > I recommend using SSD's, see: > > http://juniper.cluepon.net/index.php/Replacing_the_harddisk_with_solid_state_f > lash > > Regards, > Jonas > >>>> Hello, >>>> >>>> I was wondering if anyone has successfully replaced a hard disk on a M7i >>>> RE-5.0. If so with what model disk, and once installed what is the >>>> procedure >>>> to get the disk back to working/formatted condition. >>> >>> No magic involved. Just replace it with a disk of the same or greater >>> capacity. Be sure it's one rated for continuous operation, not a >>> standard laptop drive. (This will make the drive a lot more expensive!) >>> >>> >>> Then just "request system snapshot partition" for format, partition, load >>> the drive. >> >> Make sure the jumper on the drive is set to "slave" mode. >> >> - Kevin >> _______________________________________________ >> juniper-nsp mailing list juniper-nsp@puck.nether.net >> https://puck.nether.net/mailman/listinfo/juniper-nsp > > > _______________________________________________ > juniper-nsp mailing list juniper-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/juniper-nsp _______________________________________________ juniper-nsp mailing list juniper-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/juniper-nsp