extra info down..
Citeren Tom Hendrickx <[EMAIL PROTECTED]>:
> Hallo Eric,
>
> Citeren Eric Spakman <[EMAIL PROTECTED]>:
>
>> Hello Tom,
>>>>
>>>>
>>>>> Ok thanks .. I have no idea how I could have looked over it in the
>>>>> ISO
>>>>> image, but I did :$
>>>>>
>>>>> Making it work is another problem I fear
>>>>>
>>>>>
>>>>>
>>>>> I've added the bridge.lrp .. put it also in leaf.cfg
>>>>> bridge.o is also added and for my interface : e100.o
>>>>>
>>>>> and in interfaces is only this selected : auto br0 iface br0 inet
>>>>> static address 192.168.1.254 netmask 255.255.255.0 broadcast 10.0.0.255
>>>>> bridge_ports eth0 eth1
>>>>>
>>>>
>>>> Your broadcast address is not correct, it should be 192.168.1.255
>>>>
>>>
>>> sorry, by copying and adapting from another mail I forgot to change the
>>> broadcast address here .. it's the correct one on my system :
>>> 192.168.1.255
>>>
>> Did you load the bridge.lrp package (in leaf.cfg)? In other words, did you
>> see the bridge activating messages and is the brctl program available?
>>
>
> I did load the bridge.lrp package(just put it in the folder and
> leaf.cfg right?)
> then I get these messages on startup :
>
> eth 1 entered promiscious mode
> br0 is entering learning state (both ports)
> ...
> waiting for br0 to get ready
> then it says that eth0 and eth1 is up 100mB full duplex ..
>
> the brctl also works .. And when giving the show command it gives the
> bridge name, bridge id, spanning tree protocol is not enabled, but no
> need for that in my topology and it also gives the two interfaces
> eth0 en eth1 ..
>
> ok, something new I found out .. From the bridge I can ping to both
> pc's connected with it .. But I can still not ping to the bridge
>
Maybe it's practical to know that when I try to ping the bridge, the
bridge does notice it..
in showmacs br0 the mac addresses of both pc's appear when I ping of
just one of them .. So one way or another .. It doesn't recognize its
own ip address ..
again in config interfaces file I have solely this :
auto br0
iface br0 inet static
address 192.168.1.254
netmask 255.255.255.0
broadcast 192.168.1.255
bridge_ports eth0 eth1
in host ip addresses it stays the same, just the localhost and the
firewall, in networks I only have the localnet like by default ..
I hope this information proves useful ..
Tom
> Grtz,
>
> Tom
>
>
>> Eric
>>
>>
>>
>
>
>
-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://ad.doubleclick.net/clk;164216239;13503038;w?http://sf.net/marketplace
------------------------------------------------------------------------
leaf-user mailing list: leaf-user@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/leaf-user
Support Request -- http://leaf-project.org/
