I'm looking for recommendations on a programmer that can handle most
Flash parts. I need 29F040 32 pin PLCC's handled for my current
project but it would be wise to get something versatile for the
future.
I'm used some nice Data I/O units in the past before I was able to
host and target development on Linux. Unfortunately, everything has
always been crippled with only DOS/Windoze interfaces. I poked around
sites for some of the smaller manufacturers of programmers but found
nothing more than support for DOS/Windoze again.
Can anybody recommend a unit that can be used from Linux? It could even
be something somebody has used a DOS interface successfully from DOSEMU
on a Linux box if I have to go that route.
Thanks,
--
Matt Porter
[EMAIL PROTECTED]
--
To unsubscribe from this list, send a message to [EMAIL PROTECTED]
with the command "unsubscribe linux-embedded" in the message body.
For more information, see <http://waste.org/mail/linux-embedded>.
