I highly recommend the EMP-20 from Needham's Electronics.
http://www.needhams.com
-Corwin
Matt Porter wrote:
>
> I'm looking for recommendations on a programmer that can handle most
> Flash parts. I need 29F040 32 pin PLCC's handled for my current
> project but it would be wise to get something versatile for the
> future.
>
> I'm used some nice Data I/O units in the past before I was able to
> host and target development on Linux. Unfortunately, everything has
> always been crippled with only DOS/Windoze interfaces. I poked around
> sites for some of the smaller manufacturers of programmers but found
> nothing more than support for DOS/Windoze again.
>
> Can anybody recommend a unit that can be used from Linux? It could even
> be something somebody has used a DOS interface successfully from DOSEMU
> on a Linux box if I have to go that route.
--
Corwin Nichols, President
Microtech Systems
2 Davis Dr., Belmont, CA 94002 Ph: 650-596-1900 ext. 111
email: [EMAIL PROTECTED] Web: www.microtech.com
--
To unsubscribe from this list, send a message to [EMAIL PROTECTED]
with the command "unsubscribe linux-embedded" in the message body.
For more information, see <http://waste.org/mail/linux-embedded>.
