On Mon, 12 Jun 2000, Dunlap, Randy wrote:
> Is this with usbcore, an hcd, and the USB printer
> driver built in-kernel, not as modules?
As modules. The printer module wasn't loaded at boot time though. It dumps
the stuff telling you about the unrecognised device. I then load the
module and get messages like (this isn't one though);
printer.c: usblp_control_msg: rq: 0x01 dir: 1 recip: 1 value: 0 len: 0x1
result: 1
But the printer does nothing. If I then cycle power on the printer the
same messages appear but I can print. (cat /etc/fstab >/dev/usb/usblp0 is
that I do to make sure lpd isn't screwed up).
> I just tested this (power cycle my PC with printer
> connected) with modules and it works as it should(tm).
I'm not that bothered, as it does work. I'll retry again with the printer
module getting loaded at the same time as usb-uhci and usbcore.
--
/------------------------------+-=-=-=-=-+-------------------------\
|Stephen J. Gowdy |A4000/040| Mail Stop 50A-2160, LBL, |
|http://www.ph.ed.ac.uk/~gowdy/ | 1GB HD| 1 Cyclotron Rd, Berkeley,|
| |20MB RAM| CA 94720, USA |
|InterNet: [EMAIL PROTECTED] |3.4xCDROM| Tel: +1 510 495 2796 |
\------------------------------+-=-=-=-=-+-------------------------/
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
