Chris,
The little pipe that comes out the bottom of the carbie on the rocker cover
side is the vac pipe (remember to run it direct to the dizzy with a DGAV)
and the mixture screw is the one to the rear of the pipe. When you adjust
the mixture, make sure you don't screw the mixture in to tightly (lean) as
the thread is very fine - stop once you feel resistance and then screw it
out until the idle doesn't increase any more (rich). They are quite
sensitive to mixture adjustment even on the rich side so it's easy to set is
right. Before you fit the carbie, it would also be a good idea to carefully
take the top cover off and check the primary and secondary jet sizes so you
know what you have in case you have to get bigger ones. Around 140 primary
and 160 secondary are ball park for a L20B.
regards
Terry
-----Original Message-----
From: [EMAIL PROTECTED]
[mailto:[EMAIL PROTECTED]]On Behalf Of Chris Williams
Sent: Friday, 15 June 2001 8:42
To: [EMAIL PROTECTED]
Subject: RE: Webbers Info
Thanks again Terry
I did get one to day and an adapter I am going to install it tomorow I
think just with the water choke should be prety straght forward. One
question thow do you know what the little pipe is for vacuum sensor
maybe?
Regards
Chris.
--membersozdat-------------------------------------------------------
OZDAT Mailing List Please Note:-
Send (un)subscribe requests to [EMAIL PROTECTED]
Send submissions to [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------
