Hi Cam, FYI, I have Stewart's adjustable arms, and I can adjust them by removing ONLY the inner pivot point nut. I am also running 6 deg castor and 3 deg neg, It is fairly tight and you need to give it a bit of a shove to get the hole over the pin again, but I never had a problem with it. I can adjust em in under 10 minutes per side.
Cheers, Chris Howard [EMAIL PROTECTED] http://turbovan.com > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED]] On Behalf Of CM510 > Sent: Saturday, 23 February 2002 11:10 PM > To: [EMAIL PROTECTED] > Subject: Re: Whiteline suspension upgrade > > > Hi James :) > > I know where you're coming from but I can't do it that way. > Don't know what > caster you run, but I'm running 6 deg positive. This means > you can't just > un-do the nut off the back of the lower control arm pivot > point and pull it > back over the bolt, it just will not go. If you can picture > the wheel end > of the control arm being pulled forward by the radius rod and > the pivot end > has to go back the opposite way to get over the pivot bolt. > > I bought them thinking they would adjust simply by doing as > you describe, > but the only way to do it (for me anyway) is to pull it off > the strut as > outlined earlier. > > Cam > CM510 > www.sprite.com.au/cm510 --membersozdat------------------------------------------------------- OZDAT Mailing List Please Note:- Send (un)subscribe requests to [EMAIL PROTECTED] Send submissions to [EMAIL PROTECTED] No unauthorised redistribution of this email http://www.ozdat.com/ozdatonline/index.htm http://www.ozdat.com/ozdatonline/listindex.html http://www.mail-archive.com/[email protected]/ ---------------------------------------------------------------------
