280ZX uses a licenced version of the Bosch L-Jet system.  It is 
purely analogue and has no microprocesser as such - there is no 'limp 
home' mode with this system.


>I know SFA about these but what chances it's running in Limp Home Mode? What
>else causes that other than low battery voltage?
>It happened to me once, not in a Datto and it takes some figuring, well for
>me it did as it felt like low fuel pressure.
>
>regards
>Terry
>
>-----Original Message-----
>From: [EMAIL PROTECTED]
>[mailto:[EMAIL PROTECTED]]On Behalf Of
>[EMAIL PROTECTED]
>Sent: Wednesday, 3 April 2002 10:10 PM
>To: [EMAIL PROTECTED]
>Subject: L28E troubles :-(
>
>
>Is anyone familiar with the EFI from a 280ZX? I've just fitted an L28E from
>a 280ZX into a 1975 Datsun Laurel complete with the injection and I have a
>problem. I've wired it up as it should be according to the Nissan diagram
>and it started first time but won't rev over 1800 rpm! At that speed the
>injectors cut out and it dies until the revs have dropped a bit then the cut
>back in.
>
>I've checked all the connections and everything seems fine. The system was
>running fine before the transplant. At first I thought it may be a faulty
>AFM but I've tested it and the wiring harness and it's fine. I've even tried
>a different AFM but there was no change. The fuel pressure is fine (I tested
>the VW pump before fitting and it was good and I've fitted a new regulator)
>
>The only connection from the ignition to the ECU is the one from the
>negative terminal on the coil to pin#1 on the ECU....could this be causing a
>problem?
>
>Anybody got any ideas?
>
>Cheers,
>
>Eddie Rattley
>England
>www.ratdat.com
>
>
>

--membersozdat-------------------------------------------------------
OZDAT Mailing List   Please Note:-
Send (un)subscribe requests to  [EMAIL PROTECTED]
Send  submissions to  [EMAIL PROTECTED]
No unauthorised redistribution of this email
http://www.ozdat.com/ozdatonline/index.htm
http://www.ozdat.com/ozdatonline/listindex.html
http://www.mail-archive.com/[email protected]/
---------------------------------------------------------------------

Reply via email to