I don't do much MT wireless, but 6.20+ scare me, so far. If lowering the power
doesn't help, I'd try to back level the radios to 6.18, or 6.7, and try again.
Are you using the wireless_fp package or the PRE-CAP package?
On December 15, 2014 5:50:29 PM CST, Scott Reed <[email protected]> wrote:
>The RB411L doesn't have enough umph to keep up and drops the
>connection?
>
>On 12/15/2014 5:10 PM, Nick Bright wrote:
>> Greetings,
>>
>> I have an nv2 point to point link on 5GHz-A getting this error. The
>link
>> is good, with -40/-35dBm signal (maybe too hot is the problem). 95%+
>CCQ
>> and 54Mbps modulation rates. The units are running 6.22 (RB411L) and
>> 6.23 (RB411) with the latest firmware. Radios are R52 on one side,
>and
>> R52H on the other.
>>
>> The link will sometimes drop with "lost connection, medium-access
>> timeout", coming back about 10-20 seconds later.
>>
>> Other than the signal being too hot - I'll turn that down and see
>what
>> happens - any thoughts as to what might cause the issue?
>>
>
>--
>Scott Reed
>Owner
>NewWays Networking, LLC
>Wireless Networking
>Network Design, Installation and Administration
>Mikrotik Advanced Certified
>www.nwwnet.net
>(765) 855-1060 (765) 439-4253 Toll-free (855) 231-6239
>
>
>_______________________________________________
>Mikrotik-users mailing list
>[email protected]
>http://lists.wispa.org/mailman/listinfo/mikrotik-users
--
Sent from my Android device with K-9 Mail. Please excuse my brevity.
_______________________________________________
Mikrotik-users mailing list
[email protected]
http://lists.wispa.org/mailman/listinfo/mikrotik-users
