Wait.. you using CIS-E (and) Motronic injectors in combination? They are
definitely different...
...unless I've missed something in a previous post...
Ricky
----- Original Message -----
From: <[email protected]>
To: "Holland Phillips" <[email protected]>
Cc: <[email protected]>
Sent: Monday, October 23, 2006 6:24 PM
Subject: Re: [a2-16v-list] No power/low end on new 2.0
I was hoping you could pop the sprocket off w/out pulling the cams...
Other than a new O2 sensor I didn't touch any fuel delivery components
until I started troubleshooting. I
have a bad CIS-E injector and a bad Motronic injector line(melted it
w/shop light) so I have a mixed bag of
injectors. Now I'm using a spare airbox, plugs, wires, knock module,
ignition module. Can't find my spare
DPR, coil or O2 control module or I would have swapped them out as well.
Did every electrical test except the
DPR.
One doubt I have is the tach reading higher than it should. I think this
happened to me before.
Anyway going to check compression and then probably open the valve cover.
Steve
