On Friday 19 November 2010 01:10:47 Jeff Gilchrist wrote: > On Thu, Nov 18, 2010 at 5:29 PM, Jason <ja...@njkfrudils.plus.com> wrote: > > I'm assuming case 3 is on the same machine as the failed case ? > > Yes, they are the same machine. > > > Did the previous mpir v2.1 fail with the same options ? > > I just checked an v2.1.3 also fails with the same options enabled > > > Can you try it without the --enable-assert to see if it's some old > > assertion getting in the way , and also perhaps without --enable-cxx to > > see if it's the c++ being a problem. > > The machine works fine with just --enable-cxx, I also tried with just > --enable-fat and I get the failure so it seems to be a fat thing. > > > Do you have another compiler on that system to try ? , in case it is that > > particular compiler setup. > > The only other compiler on the system is pathscale which is a variant > of gcc and gives the same error. > > > You could try replacing mpn/x86_64/fat/fat_entry.asm with the version > > from mpir v2.1 , as the file has changed , but only a little bit ! > > Since the compile error is happening with 2.1, I figure there isn't > much point in trying this. > > Jeff.
Thanks , I have no idea what it is , the only thing I can suggest for the moment is to try a build for static only , and then in a clean dir a shared build only. I'm not sure what it will tell us !!! Another possible thing to try is to make mpir on the broken machine as far as it will go , tar it up , and transfer to another machine and try make , if the time stamps are OK , it should proceed from where the broken machine left off. If we are lucky the build will complete , it may not for many reasons , but it may??? tell us some thing useful , I'm clutching at straws here... Thanks Jason -- You received this message because you are subscribed to the Google Groups "mpir-devel" group. To post to this group, send email to mpir-de...@googlegroups.com. To unsubscribe from this group, send email to mpir-devel+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/mpir-devel?hl=en.
