|
HOORAY! i'm getting close! thanks for all of your
help. I used /dev/modem under kppp and it queried my LT linmodem but it
did not respond. i tried to dial up any ways and it didnot initialize. when i
ran the query it found the modem but it did not give any response back.. under
my isapnp.conf the modem is set to irq 3 or 4 cant remember cauze i had to come
back to windoze.. my bios says its on 9 when my machine boots up.. could this be
the problem?
roy
----- Original Message -----
Sent: Sunday, December 16, 2001
1423
Subject: Re: [newbie] Linmodems
Hi Roy,
Same basic configuration as me. Before we try
anything more complicated, you
should go into the kppp , setup tab. In
there, under 'device' you should try
the /dev/tty0 or /dev/tty1 .
Also,
I have flow control set to xon/xoff. Under the 'modem' tab, there is a
'query' button. You could give that a try and see if your modem is
responding
at all.
I'm sure you're very close.
Regards,
Bill
W.
On Sunday 16 December 2001 10:37, you wrote:
> I'm am using a
LT winmodem(lucent chip) and
>
ltmodem-kv_2.4.8_34.1mdk-6.00b7-1.i586.rpm. it installed a device.. i
think
> using /dev/ltmodem ? linux rpm installers dont tell you much of
what they
> are doing..
>
> also.. thanks for refering the
basiclinux course. i have signed up for
> it...
>
>
roy
> ----- Original Message -----
> From:
Bill Winegarden
> To: [EMAIL PROTECTED]
>
Sent: Saturday, December 15, 2001 2051
> Subject: Re:
[newbie] Linmodems
>
>
> Hi
Roy,
> I was in the same boat as you. I needed a ltmodem
driver for my modem to
> work. If you could supply a little
more information; specifically which
> modem you are using, which 'rpm'
did you use, I might be able to help.
> There are many on this list who
can supply the answers you seek.
>
>
Regards,
> Bill W.
>
> On Saturday
15 December 2001 23:18, you wrote:
> >
ok..
> >
> > I'm new to this
wonderful thing called linux, but i love it. i
> >
understand the file system and the fact that everything is a file.
i
> > know there is support for some linmodems, including
the one i my
> > machine. 8.1 did not autodetect it
so i went on a search for a rpm
> > that would work and
found one. i installed it, but cannot get the
> >
internet dialer to recognize it. is there another dialer i can use
..
> > or would it be best to by an external
modem?.
> >
> > i have the same
problem with my PDA.. the soft where is there, but it
> >
is looking @ /dev/polit when it is connect to comm2.. does any one
know
> > of some free training one the web or some good
books i can read. i want
> > to use my machine on the web
instead of going under windoz all the
> >
time..
> >
> >
thanks
> >
> > roy
>
>
---------------------------------------------------------------------------
>---
>
>
>
Want to buy your Pack or Services from MandrakeSoft?
> Go to
http://www.mandrakestore.com
Want to buy your Pack or Services from MandrakeSoft?
Go to http://www.mandrakestore.com
|
