At 28/09/05 01:07, Brad Velander wrote:
I can't recall at the moment what exactly I ran into but Software
Arcs did cause me a problem at one point. Since then I never turn
them on. (Haven't seen the problem again so I have forgotten what
the precise problem was.)
In a nutshell: they mess up your clearance. Start and endpoints of
the individual segments are OK because they sit on the true arc but
the line segments in between violate your clearance, literally by
cutting corners.....
Leo Potjewijd
hardware designer
Integrated Engineering
Paasheuvelweg 20
1105 BJ Amsterdam
The Netherlands
T +31 (0)20 46 20 755
F +31 (0)20 46 20 756
E [EMAIL PROTECTED]
I http://www.smart-ID.com
De informatie opgenomen in dit bericht kan vertrouwelijk zijn en is
uitsluitend bestemd voor de geadresseerde. Indien u dit bericht
onterecht ontvangt, wordt u verzocht de inhoud niet te gebruiken en
de afzender direct te informeren door het bericht te retourneren.
The information contained in this message may be confidential and is
intended to be exclusively for the addressee. Should you receive this
message unintentionally, please do not use the contents herein and
notify the sender immediately by return e-mail.
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
