Leo,
No the simple clearance issue is not what I had run into. It's been a
while so it is bugging me trying to remember precisely what did occur with the
software arcs enabled that had me turn them off from then on.
Sincerely,
Brad Velander
Senior PCB Designer
Northern Airborne Technology
#14 - 1925 Kirschner Road,
Kelowna, BC, V1Y 4N7.
tel (250) 763-2329 ext. 225
fax (250) 762-3374
-----Original Message-----
From: Leo Potjewijd [mailto:[EMAIL PROTECTED]
Sent: Tuesday, September 27, 2005 11:04 PM
To: Protel EDA Discussion List
Subject: RE: [PEDA] arcs in Gerber go the wrong way
At 28/09/05 01:07, Brad Velander wrote:
>I can't recall at the moment what exactly I ran into but Software
>Arcs did cause me a problem at one point. Since then I never turn
>them on. (Haven't seen the problem again so I have forgotten what
>the precise problem was.)
In a nutshell: they mess up your clearance. Start and endpoints of
the individual segments are OK because they sit on the true arc but
the line segments in between violate your clearance, literally by
cutting corners.....
Leo Potjewijd
hardware designer
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
