Robison, Michael R NAVSEA wrote:
When I moved the schematic to the PCB using the update PCB, it autorouted
and looked pretty good. Looking closer, I was shocked to see that none of
the relays were on the PCB. What happened? There are a dozen of them,
and they have a distinctive round footprint that would be hard to miss.
Have you specified a footprint name on the schematic? If so, does that
footprint exist in the PCB library?
In PCB, do a Jump Component to K1 (or whatever RefDes the missing relays use)
to see if the relays have been placed, but have a different footprint than you
expect.
I did an update on the PCB and it showed several updates which I executed.
I then looked on the PCB and the relays still aren't there. I updated
again and the same update listed out again. This isn't right, is it?
Without any new changes, it shouldn't list new updates, should it? It
makes me think that for some reason, the PCB is not accepting the updates,
but I'm not getting any catastrophic failure messages. There were no
errors showing when I previewed the updates.
When you do "Update PCB", does it show any errors?
--
Peter Bennett
TRIUMF
4004 Wesbrook Mall, Vancouver, BC, Canada
GPS and NMEA info and programs:
http://vancouver-webpages.com/peter/index.html
____________________________________________________________
You are subscribed to the PEDA discussion forum
To Post messages:
mailto:[email protected]
Unsubscribe and Other Options:
http://techservinc.com/mailman/listinfo/peda_techservinc.com
Browse or Search Old Archives (2001-2004):
http://www.mail-archive.com/[email protected]
Browse or Search Current Archives (2004-Current):
http://www.mail-archive.com/[email protected]
