When I moved the schematic to the PCB using the update PCB, it autorouted and looked pretty good. Looking closer, I was shocked to see that none of the relays were on the PCB. What happened? There are a dozen of them, and they have a distinctive round footprint that would be hard to miss.
I did an update on the PCB and it showed several updates which I executed. I then looked on the PCB and the relays still aren't there. I updated again and the same update listed out again. This isn't right, is it? Without any new changes, it shouldn't list new updates, should it? It makes me think that for some reason, the PCB is not accepting the updates, but I'm not getting any catastrophic failure messages. There were no errors showing when I previewed the updates. My schematic is multi-paged, so I looked at my main to make sure that I hadn't somehow unincluded a page, but it looked OK. Any help would be appreciated. Thanks, Michael ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
