I have a problem with a multi sheet schematic. I have 5 pages (one is a separate PCB) in my design.
Page 1 is the master sheet, on it (apart from plain Text) is 3 sheet symbols. Pages 2-4 are sub schematics (CPU on 2, Ethernet on 3, misc on 4) I am getting funny errors on ERC. I am using Protel 99SE SP6. On one sheet, I have an RJ45 with built in magnetics, 4 caps attach to this device via 4 wires. Where each CAP and WIRE join, I have an ERC error. IF I zoom right in and click and hold on the wire (I use Blue for wires and black pins on parts (Protel Default IIRC) the spot where they meet turns yellow while I keep the left button down. I assume this means that the Pin and Wire are Joined. I also have parts with wire from pin to bus entry, bus entry to bus, then somewhere else on the bus I have bus entry to wire wire to resistor. ONE end of this net is fine (no ERC) but the other end has a marker, saying open connection to passive. I KNOW THE NETS are the same as I type in once then use drop down box to select the second one. Any ideas ??? -- Regards, Kat. --------------------------------------------------------------- K.A.Q. Electronics Website: www.kaqelectronics.dyndns.org IM: Yahoo: PinkyDwaggy MSN: [EMAIL PROTECTED] For Everything Electronics Phone: 0419 923 731 --------------------------------------------------------------- -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.385 / Virus Database: 268.3.2/293 - Release Date: 26/03/2006 ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
