Steve Hendrix wrote: > I recall the visual indicator being a bit misleading in this regard. > Best way to know where the hotspot is, as described earlier, is to > run a wire across the entire length of the pin, extending beyond it > on both ends. This will cause an autojunction at the hotspot, so > there will be no question where it is.
Did that on a few of the problems, the junction dot appeared right on the end of the component where I would expect it :( > > It sounds like you're on the right track with removing and adding the > library back, but you might still have a problem with the parts being > cached, especially if there are still instances of that part on the > schematic. Try (from the lib editor, with the schematic also open) > "Update Schematic". You might even have to go so far as to create a > different name for the part in order to be absolutely sure you're > getting the new part. Even tried cutting and pasting one sheet into a new design, still had the same errors (plus more due to missing sheets etc) -- Regards, Kat. --------------------------------------------------------------- K.A.Q. Electronics Website: www.kaqelectronics.dyndns.org IM: Yahoo: PinkyDwaggy MSN: [EMAIL PROTECTED] For Everything Electronics Phone: 0419 923 731 --------------------------------------------------------------- -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.1.385 / Virus Database: 268.3.2/293 - Release Date: 26/03/2006 ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
