At 2006-05-21 21:25 +1000, you wrote: >I have a pcb design which compiles and checks out 100% implying that >all components and tracks are where they should be. However when I >do a print preview the board is pushed up to the top of a page >(board size is around than A4 and showing on A3 at the top). I have >tried turning on ALL layers and unhiding everything I can think off >but nothing shows up outside the board area. Select Outside Area >comes up blank.
Select Outside only gets those things that are completely outside. You might have i.e. a component with a refdes gone walkabout. Try instead, Select All, followed by Deselect Inside and see if the result is different. Steve Hendrix ____________________________________________________________ You are subscribed to the PEDA discussion forum To Post messages: mailto:[email protected] Unsubscribe and Other Options: http://techservinc.com/mailman/listinfo/peda_techservinc.com Browse or Search Old Archives (2001-2004): http://www.mail-archive.com/[email protected] Browse or Search Current Archives (2004-Current): http://www.mail-archive.com/[email protected]
