Hi Mike, Thanks for your advice.
It worked by using Interactive startup to stop WINE I re-installed RH7.2 choosing LILO bootloader instead of Drub. After installation completed PC re-started and halted on LIL- I used the boot disk to start RH 7.2. This time it went straight through without problem with KDE started (default). My questions are ; 1) How to correct LIL- to boot Linux 2) What are the advantage and disadvantage between LILO and Drub Thanks in advance. B.R. Stephen At 10:21 PM 12/16/2001 +0000, you wrote: >have you tried pressing I (i) just after the kernel boots up, this will enter >interactive startup and allow you to stop wine from starting (if that makes >sense?). Then disable wine from services until you diagnose your problem. > >you can press I any time after you see the welcome to RedHat line. > >HTH > >Mike > >RE: RH 7.2 fails to re-start after installation. >On Sunday 16 December 2001 16:25, you wrote: > > Hi All People, > > > > I newly installed RH 7.2 as workstation on an AMD PC with ATA-66 card (ABIT > > Hot Rod 66 adapter card) as SCSI adapter. Installation went through > > without problem. At re-starting it moved on smoothly until it came to : > > > > INIT : Switching to runlevel : 3 > > INIT : Sending processes to TERM signal > > tStarting automount : No Mountpoint Defined [OK] > > Starting lpd : No printers Defined [OK] > > Starting Wine [Failed] > > > > then the PC halted. > > > > I force-re-set (re-started) the PC. It halted again at the same point. > > > > Any remedy or pointer ? > > > > Thanks in advance. > > > > B.R. > > Stephen Liu _______________________________________________ Redhat-list mailing list [EMAIL PROTECTED] https://listman.redhat.com/mailman/listinfo/redhat-list