I have placed a call to find that out, mine are no wheres near me. If
I get the information back, I will post it here. 13" sounds correct. My
duplexer has PL connectors on it. Here is what you could do now. Your cables should be electrically 1/4 wave length (or ODD multiples of). I would suggest that you take some RG 214 and do a little math. 1/4 wave at your operating frequency multiplied by the velocity factor of the cable to come up with the actual length. Cut your cable to this length and put connectors on it STRICTLY following directions and NOT cutting excess to do the connector. (I have no clue what that is on 214) (low and high can cut the same since cables will work to about 10% error). NOTE - Depending on where your cans were before, you may have to mess with the reject stubs on the side. QUESTION ANSWERED. again, if I get the information back I will post it. James Neal Newman wrote:
Yahoo! Groups Links
|
- Re: [Repeater-Builder] Off topic - HT repair Mike WA6ILQ
- Re: [Repeater-Builder] Off topic - HT repair Mark Holman
- Re: [Repeater-Builder] Off topic - HT repair Neal Newman
- Re: [Repeater-Builder] wacom wp-641 Neal Newman
- Re: [Repeater-Builder] WACOM WP-641 Duplexer Eric Lemmon
- Re: [Repeater-Builder] WACOM WP-641 Dupl... Neal Newman
- Re: [Repeater-Builder] WACOM WP-641... Joe
- Re: [Repeater-Builder] WACOM WP-641... Kevin Custer
- Re: [Repeater-Builder] WACOM WP... Neal Newman
- Re: [Repeater-Builder] WACOM WP... James
- Re: [Repeater-Builder] WACOM WP... Neal Newman
- Re: [Repeater-Builder] WACOM WP... XE2SI
- Re: [Repeater-Builder] WACOM WP... Neal Newman
- Re: [Repeater-Builder] WACOM WP-641 Dupl... Tony King - W4ZT
- Re: [Repeater-Builder] WACOM WP-641... James
- Re: [Repeater-Builder] WACOM WP... Bob Dengler
- Re: [Repeater-Builder] WACOM WP... James
- [Repeater-Builder] Re: WACOM WP... Coy Hilton
- Re: [Repeater-Builder] Re: WACO... Bob Dengler
- [Repeater-Builder] Re: WACOM WP... Coy Hilton