Tell us how, please. I ended up using PL and DPL but not at the same time. The Kenwood's community panel allows multiple PLs and crossover as required but only one can be used at a time. Another quirk is that the repeater must drop before it will respond to a different PL or DPL input.
So, how did you go about simultaneous PL/DPL? de WD7F John in Tucson ----- Original Message ----- From: "mch" <[EMAIL PROTECTED]> To: <Repeater-Builder@yahoogroups.com> Sent: Monday, July 02, 2007 9:17 AM Subject: Re: [Repeater-Builder] ctcss and dcs at same time? I've done it successfully. Joe M. DaveH wrote: > > chances are one will interfere with the other. They would but be present > and active at the same time. I have never seen it done successfully. > David R. Henry LME > Licensed Master Electrician > Amateur Radio W2DRH > Member ARRL > Accredited Instructor > > ----- Original Message ----- > From: "Jim" <[EMAIL PROTECTED]> > To: <Repeater-Builder@yahoogroups.com> > Sent: Monday, July 02, 2007 11:08 AM > Subject: Re: [Repeater-Builder] ctcss and dcs at same time? > > > ku4zs1 wrote: > >> Is it possible to run CTCSS and DCS at the same time on a > >> transmitter? Aside from the fact that most radios will not allow you > >> to select both at the same time (I will be using an outboard DCS > >> encoder and the built in CTCSS encoder). I am not sure if they are > >> capable of both running at the same time. Thanks. > > > > Chances are-the transmitter will be perfectly happy. The decoder on the > > other end most likely will not. > > > > I have never been successful at it, even using a good service monitor > > with an outboard DCS encoder (test instrument grade, I think it was a > > Motorola box) as the 'trasnmitter'. Several different radios, none would > > decode both. > > -- > > Jim Barbour > > WD8CHL > > > > > > > > > > > > > > Yahoo! Groups Links > > > > > > > > > > > Yahoo! Groups Links > > > Yahoo! Groups Links -- No virus found in this incoming message. Checked by AVG Free Edition. Version: 7.5.476 / Virus Database: 269.9.14/883 - Release Date: 7/1/2007 12:19 PM Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/Repeater-Builder/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/Repeater-Builder/join (Yahoo! ID required) <*> To change settings via email: mailto:[EMAIL PROTECTED] mailto:[EMAIL PROTECTED] <*> To unsubscribe from this group, send an email to: [EMAIL PROTECTED] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/