Yes, it was resolved at a lot of commercial sites by not allowing it to be used ;-)
Usually after a bit of time, the cable will start to become a source of noise as the two dissimilar metals start to react with each other. There are many documented cases of this problem. Search this group's messages and you'll see this has been discussed over and over. It comes up about every other week. The manufacturers do not list these cables for low PIM. There's info on the Repeater Builder site here: http://www.repeater-builder.com/antenna/pdf/recommended-coax-and-connectors-for-iden.pdf Personally, I've seen it cause problems on several sites. Getting it out of service solved the problem. Chuck WB2EDV ----- Original Message ----- From: WA3GIN To: [email protected] Sent: Sunday, January 03, 2010 1:34 PM Subject: Re: [Repeater-Builder] Mastr II mods and parts I believe the issues with LMR were resolved years ago Chuck. Can you refresh the group on some of the primary issues? Thanks, dave p.s. we've been using it for five years at ten sites with no problems.
