From: Alan Lambert Lone Star Flyer club Arlington, Texas Tip for everyone with a drill press. You can use a pin vice for small diameter drill bits. Just cut the handle shorter so there will not be any wobble and the drill bit will drill straight. Thanks, Alan
From: Howard Sheffield <[email protected]> To: [email protected] Sent: Thursday, August 18, 2011 4:53 PM Subject: Re: {S-Scale List} Re: Seek And Ye Shall Find Hi Andre I found that I had to use the chucks from my dremel set to use my drill press with the micro bits. I bought the set of chucks at Home Depot. Howard Sheffield On Aug 18, 2011, at 6:32 AM, Andre Ming wrote: > Hi Dave: > > Thanks for the tip on the carbide drill bits. I have a drill press... but I > don't know if it will chuck down to .020". I'll have to remember to check > that. > > Andre Ming > > > If you want to drill small holes in a steel frame find a friend > > with a drill press and then buy small carbide bits of the correct > > size. > > [Non-text portions of this message have been removed] > > [Non-text portions of this message have been removed] ------------------------------------ Yahoo! Groups Links [Non-text portions of this message have been removed] ------------------------------------ Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/S-Scale/ <*> Your email settings: Individual Email | Traditional <*> To change settings online go to: http://groups.yahoo.com/group/S-Scale/join (Yahoo! ID required) <*> To change settings via email: [email protected] [email protected] <*> To unsubscribe from this group, send an email to: [email protected] <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/
