Hello:
Jonas Diemer wrote:
> Or triangular (trapezoid with DeltaX=SizeX)...
>
Sorry for the reply answer, dealing with yahoo mail
is horrible, I had to use the web interface...
Thanks a lot for your ideas. Finally I solved it
using trapezoid pads.
Triangle were not that nice, because of t
I am using build 2008-0416-r982 and have run into a problem.
I place my components and ran FreeROUTE. It did quite well with only
one trace unrouted. I manually routed the remaining trace and saved.
Unfortunately I now see two problems. First, when I start Gerbview
and load the edges layer, the
I created a simple pcb (with pic microcontroller IC) and I selected a
3D view mode. Another window was opened, but it was blank. Why is
that? Does that mean that there is no 3D view model of that IC in the
library or am i missing something.
I am using ubuntu 7.10 and kicad 2007.
Regards
Klemen
Please install latest svn snapshot from http://www.beischer.com/kicad
Milan
klemen_dovrtel napsal(a):
>
>
> I created a simple pcb (with pic microcontroller IC) and I selected a
> 3D view mode. Another window was opened, but it was blank. Why is
> that? Does that mean that there is no 3D view m
Perhaps you have something located at a large offset in the second file you
loaded. If this were the case, a zoom to full screen on the second layer
would require a zoom out. This could also explain the GC-Preview error.
David
> -Original Message-
> From: Doug [mailto:[EMAIL PROTECTED]
>
Any ideas on what to look for either in Gerbview, PCBNEW, or in the
file itself? I check all files and found:
component layer has the offset
copper layer has the offset
component layer silk has the offset
copper layer silk is ok (there are no components on the layer)
edges layer is ok
Regards,
--- In kicad-users@yahoogroups.com, "Doug" <[EMAIL PROTECTED]> wrote:
>
> I am using build 2008-0416-r982 and have run into a problem.
> I place my components and ran FreeROUTE. It did quite well with only
> one trace unrouted. I manually routed the remaining trace and saved.
> Unfortunately I n
Dick,
Thanks for the feedback. Auto zoom confirms that the problem is in
the board design, not caused by the gerber output. After I auto zoom,
the pcb shrink to a few pixels and a cursor shows up about a third of
the screen away from the upper right. The zoom level and coordinates
shown on the
--- In kicad-users@yahoogroups.com, "Doug Deeds" <[EMAIL PROTECTED]> wrote:
>
> Dick,
>
> Thanks for the feedback. Auto zoom confirms that the problem is in
> the board design, not caused by the gerber output. After I auto zoom,
> the pcb shrink to a few pixels and a cursor shows up about a thir
Dick,
Thanks for your latest comments. I noticed two things that allowed me
to narrow the problem down. First, I ripped up all traces, but the
gerbers and pcb still had the problem. Second, I noticed that an
8-pin connector did not seem to be anchored on pin 1 as expected.
When I went into the
10 matches
Mail list logo
