Hi Bill

Can you tell me the most practical way to measure the milliamps at the 
secondary of a nominal  120 V 60 Hz 10KV center-tapped transformer?  I 
would rather not cut the wire, because the maker says the configuration is 
very sensitive to even minor changes in the physical layout.

I have a Fluke 87 and an inductive pickup, but am spooked about frying the 
meter.  I asked Fluke, and they said the transformer was not rated for that 
voltage.  Other than an insulation breakdown, what distortion of the 
measurement or harm to the meter would you consider.

Thanks in advance,


James Osbourne Holmes
[email protected]


-----Original Message-----
From:   2001 TV  VCR [SMTP:[email protected]]
Sent:   Friday, November 12, 1999 1:40 PM
To:     [email protected]
Subject:        CS>LOW OR HIGH VOLTAGE?

I have not seen anyone discuss the best method for
making high quality CS.  One of the manufacturers of
high voltage (10,000 volts AC) CS generators claims
that the low voltage (30 volts DC) systems are worthless.

I have been using 30VDC first using thin silver wires and
a 16 oz. jar and now a gallon jar with a much larger silver
electrode.  Without current limiting most of the silver ends
up on the cathode (negative electrode).  Some of you
suggested limiting the current to a milliamp or so and
going for quite a few hours.

Can some of you offer more opinions and suggestions
along these lines.  Let us know what type of equipment
and voltages/currents you are working with if getting good
results.  It is so important that all of us end up with CS that
is effective and safe to use.

If any of you have questions about electrical or electronic
circuits involving you CS equipment I can help.

Bil Green
2001 TV VCR




--
The silver-list is a moderated forum for discussion of colloidal silver.

To join or quit silver-list or silver-digest send an e-mail message to:
[email protected]  -or-  [email protected]
with the word subscribe or unsubscribe in the SUBJECT line.

To post, address your message to: [email protected]

List maintainer: Mike Devour <[email protected]>