If you get any arcing, the high frequencies can couple through the insulation
and blow the meter.  Blew out a digital voltmeter when I tried it.  I have
since gone to cheap radio shack mA analog meters with a diode across it, much
more robust.

Marshall

James Osbourne, Holmes wrote:

> Hi Bill
>
> Can you tell me the most practical way to measure the milliamps at the
> secondary of a nominal  120 V 60 Hz 10KV center-tapped transformer?  I
> would rather not cut the wire, because the maker says the configuration is
> very sensitive to even minor changes in the physical layout.
>
> I have a Fluke 87 and an inductive pickup, but am spooked about frying the
> meter.  I asked Fluke, and they said the transformer was not rated for that
> voltage.  Other than an insulation breakdown, what distortion of the
> measurement or harm to the meter would you consider.
>
> Thanks in advance,
>
> James Osbourne Holmes
> [email protected]
>
> -----Original Message-----
> From:   2001 TV  VCR [SMTP:[email protected]]
> Sent:   Friday, November 12, 1999 1:40 PM
> To:     [email protected]
> Subject:        CS>LOW OR HIGH VOLTAGE?
>
> I have not seen anyone discuss the best method for
> making high quality CS.  One of the manufacturers of
> high voltage (10,000 volts AC) CS generators claims
> that the low voltage (30 volts DC) systems are worthless.
>
> I have been using 30VDC first using thin silver wires and
> a 16 oz. jar and now a gallon jar with a much larger silver
> electrode.  Without current limiting most of the silver ends
> up on the cathode (negative electrode).  Some of you
> suggested limiting the current to a milliamp or so and
> going for quite a few hours.
>
> Can some of you offer more opinions and suggestions
> along these lines.  Let us know what type of equipment
> and voltages/currents you are working with if getting good
> results.  It is so important that all of us end up with CS that
> is effective and safe to use.
>
> If any of you have questions about electrical or electronic
> circuits involving you CS equipment I can help.
>
> Bil Green
> 2001 TV VCR
>
> --
> The silver-list is a moderated forum for discussion of colloidal silver.
>
> To join or quit silver-list or silver-digest send an e-mail message to:
> [email protected]  -or-  [email protected]
> with the word subscribe or unsubscribe in the SUBJECT line.
>
> To post, address your message to: [email protected]
>
> List maintainer: Mike Devour <[email protected]>