Hi Marshall, On Wed, 09 Aug 2000 12:00:29 -0400, Marshall Dudley <[email protected]> wrote:
>The Clark Zapper runs approximately 9V peak to peak, not 2.6 Volts open >circuit. Once attached it may be 2.6 volts, but that is due to the current >limiting and the loading by the body to limit it to the maximum of 10 mA. I haven't checked recently, but I thought that Clark was shooting for about 7 volts for the pulse when attached (held in the hands). Also, the current limit is 1 mA, isn't it? At least, that's the safety guideline put out by one "official" group. Normal body resistance to DC current is 200,000+ Ohms. It's lower to pulses, but not low enough to put too much current (over 1 mA) through the body at 10 volts. If the pulse is only 2.6 volts, the driver circuit apparently isn't able to supply enough current, which also means that the pulse shape won't be close to a square wave. >I am >pretty sure the Beck unit also limits to 10 Ma, so it would in effect have the >same voltage as the Clark unit when attached. I wish that were true, but it's not. The beck unit (the DC blood electrifier) uses 30 to 35 volts across the electrodes -- WHEN ATTACHED! That's probably okay because the current should still be under 1 mA -- but it's close to the limit. -- Dean -- from (almost) Duh Moyn (CDP, KB0ZDF) -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the SUBJECT line. To post, address your message to: [email protected] Silver-list archive: http://escribe.com/health/thesilverlist/index.html List maintainer: Mike Devour <[email protected]>

