Martin Drautzburg ([EMAIL PROTECTED]) wrote:
> 1. modem_run alcaudsl.sys runs fine, modem syncs
Good
> 2. when running pppd call myProvider I get
>
> Dec 12 00:42:03 beaureve pppd[2083]: pppd 2.4.1 started by root, uid 0
> Dec 12 00:42:03 beaureve pppd[2083]: speed 2 not supported
> Dec 12 00:42:03 beaureve pppd[2083]: using channel 6
> Dec 12 00:42:03 beaureve pppoa3[2084]: PPPoA3 version 1.1 started by root
>(uid 0)
> Dec 12 00:42:03 beaureve pppoa3[2084]: Control thread ready
> Dec 12 00:42:03 beaureve pppoa3[2084]: Modem found!
> Dec 12 00:42:03 beaureve pppd[2083]: Using interface ppp0
> Dec 12 00:42:03 beaureve pppd[2083]: Connect: ppp0 <--> /dev/pts/0
> Dec 12 00:42:03 beaureve pppoa3[2086]: ppp(d) --> pppoa3 --> modem stream
>ready
> Dec 12 00:42:03 beaureve pppoa3[2087]: modem --> pppoa3 --> ppp(d) stream
>ready
> Dec 12 00:42:04 beaureve pppd[2083]: sent [LCP ConfReq id=0x1 <asyncmap 0x0>
><pcomp>]
> Dec 12 00:42:31 beaureve last message repeated 9 times
> Dec 12 00:42:34 beaureve pppd[2083]: LCP: timeout sending Config-Requests
The peer is not reachable, two possible reasons:
- the packets do not go out your box
- the end is not there (or cannot understand the packets you send to
it)
> 3. ...
> 4. Sometimes (after a reboot) I see something worrying:
> Dec 11 18:32:23 beaureve pppoa3[3893]: Cell had wrong VPI(191)/VCI(32)
>(OAM?) PTI=0x01
It does not hurt
>
> 5. I am puzzeled by the fact the the module pppoatm is not loaded. I
> did load it manually but it makes no difference. Aren't we doing
> ppp-over-atm here ?
The answer has been clearly detailed in another email in this thread.
> 6. Is it a problem if the ISDN system is running (ipppd running) ? It
> actually makes not difference though.
No
My advices:
1 - Make sure your password/username match the username used in the peer
file.
2 - as you're using isdn, perhaps some conf files are polluting the adsl
config. Make sure all options (including those in /etc/ppp/options) are
set in the adsl peer file.
3 - You've been kind enough to show logs but they were not so useful ;-)
Try adding verbosity to pppoa3 line in the peer file (option -v 2)
/!\
pppoa3 will dump all traffic it forwards from|to the USB modem so do let
pppd run too long because your logs will grow fast.
--
Edouard Gomez
-- Attached file included as plaintext by Listar --
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.1 (GNU/Linux)
iD8DBQE9+NPrR5dTYz5sWMcRAhM9AKCYl6/8lgmhWC+ZaJH8c9zMD3JibQCgxwNr
ZLXTD7ltVePnkrIDZ6+ZR0Y=
=niAy
-----END PGP SIGNATURE-----
Liste de diffusion modem ALCATEL SpeedTouch USB
Pour se d�sinscrire : mailto:[EMAIL PROTECTED]?subject=unsubscribe
