Thank you all who responded to my transmission removal question. You were all very helpful and i was able to pull the trans. out with no problems.
But now the more interesting (and disgusting...) is that i have a clutch kit that WILL NOT FIT!!!
You must all think that i am redculous for taking on this project since i am running into so many problems and not knowing what i am doing. But thus far you all have been a tremendous help and i could not have come this far without you. So here goes...
I must have a 1500 flywheel becuase it is too big for the 1296 clutch kit but it still fits on the engine no problems. Is this possible? Here is what i have:
Trans.# = 1481 Engine Block # = FE14769E COMM.# = FD14309
The measurments on the flywheel are approx. 11.5" (outside diameter) and the inside diameter (clutch plate surface) is approx. 7.5".
It seems that everything is 1296 (MK3), but the flywheel is wrong...again, is this possible? Now do i try to return the clutch kit and get a 1500 kit with the correct number of notches on the inside of the clutch plate to match up with the notches on the input shaft? OR should i buy a new flywheel and keep the correct clutch kit?
PLEASE HELP!!!
Thank you, Dave '68 Mk3 (I think?)
_________________________________________________________________
FREE pop-up blocking with the new MSN Toolbar get it now! http://toolbar.msn.com/go/onm00200415ave/direct/01/
*** http://www.team.net/the-local ***
Your messages not reaching the list? Check out http://www.team.net/posting.html
*** unsubscribe/change address requests to [EMAIL PROTECTED] or try *** http://www.team.net/cgi-bin/majorcool *** http://www.team.net/mailman/listinfo *** Archives at http://www.team.net/archive *** Edit your replies!
