Hello All, I do wish I could find some 1/2" Male x 1" Female Street ells for a upright to pendant conversion project.
Friday, January 17, 2014, 4:25:23 PM, you wrote: > I think it comes down to if the street elbows are made according to > the appropriate ASTM standard from Table 6.4.1. In your defense, > 6.4.6.1 states that unless circumstances exist where hex bushings > are allowed, one piece reducer fittings shall be used for a change in pipe > size. > Todd G Williams, PE > Fire Protection Design/Consulting > Stonington, CT > www.fpdc.com > 860-535-2080 (ofc) >> On Jan 17, 2014, at 3:43 PM, "Morey, Mike" <[email protected]> wrote: >> So I seem to remember this being a "no-no" but the code doesn't seem to >> explicitly prohibit us from using them. I have a tight squeeze where a 1" >> male x female "street" elbow would be helpful, but I want to make sure I'm >> not missing something in 13 that prohibits it, we use the 2010 edition. >> Mike Morey, CFPS, SET >> Planner Scheduler/Designer >> BMWC Constructors, Inc. >> 1740 W. Michigan St, Indianapolis, IN 46222 >> O: 317.651.0596 | C: 317.586.8111 >> [email protected]<mailto:[email protected]> | www.bmwc.com<http://www.bmwc.com/> >> _______________________________________________ >> Sprinklerforum mailing list >> [email protected] >> http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org > _______________________________________________ > Sprinklerforum mailing list > [email protected] > http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org -- Best regards, Charles Thurston mailto:[email protected] Systems Design Manager NICET Certified _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org
