Usually there is an instruction sheet that tells what hole saw is to be used. Until of course, the sheet is tossed. I check in the parts order and rescue the instructions and note the hole saw size in the inventory program. I also keep extra hole saws on the shelf.
I don't know if there is a code, but you have to drill a larger hole than > the outlet in order for the mech. tee to seat with the gasket on the pipe > to keep it from leaking. > > Lamar Vaughn,SET > > > > > On Wed, Feb 18, 2015 at 6:08 PM, JD Gamble <[email protected]> > wrote: > >> Does anyone know the actual Code for requiring the attachment of a drill >> out >> to a Mech Tee? >> >> >> >> I know its good practice, but does anyone know the actual code, or is >> there >> one? >> >> >> >> >> >> >> >> Life Safety Solutions of Sheridan >> >> JD Gamble >> >> [email protected] <mailto:[email protected]> >> >> (307) 763-3361 >> >> >> >> >> >> --- >> This email has been checked for viruses by Avast antivirus software. >> http://www.avast.com >> _______________________________________________ >> Sprinklerforum mailing list >> [email protected] >> >> http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org >> > _______________________________________________ > Sprinklerforum mailing list > [email protected] > http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org > _______________________________________________ Sprinklerforum mailing list [email protected] http://lists.firesprinkler.org/listinfo.cgi/sprinklerforum-firesprinkler.org
