It is good that you asked this FAQ. Basically, what is magic about the AMC-123 is that it has certifiably low phase noise, guaranteed by design and characterization, although not specified by Anzac. The other 99.9% of amplifiers that seem plausible, like this one, do not have the sophisticated negative feedback scheme of the AMC-123, and likely do NOT have good enough phase noise. In any event, we have zero information about the phase noise of this Mini-Circuits amplifier. Having a low noise figure is necessary but not sufficient to have good phase noise.
Of course you could always get lucky. But then you have to also build an amplifier phase noise measurement system, which generally entails a line stretcher. Again, thank you for asking this question. It comes up often. Would anyone else like to suggest a known good low phase noise buffer amplifier? Maybe something from a Fred Walls paper? Rick Karlquist N6RK Mark J. Blair wrote: > > On Aug 20, 2010, at 11:17 AM, Rick Karlquist wrote: >> On the 10811 production line, they would use Anzac AMC-123 amplifiers > > How does this amplifier look for this application? > > http://minicircuits.com/pdfs/ZFL-500LN.pdf > > If I understand the specifications properly, the noise figure is better > and it has higher reverse isolation and higher gain, but a lower output > intercept point. > > > > -- > Mark J. Blair, NF6X <n...@nf6x.net> > Web page: http://www.nf6x.net/ > GnuPG public key available from my web page. > > > > > > _______________________________________________ > time-nuts mailing list -- time-nuts@febo.com > To unsubscribe, go to > https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts > and follow the instructions there. > > _______________________________________________ time-nuts mailing list -- time-nuts@febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.