Well as far as I know, I just did a test upgrade though, it turned a useless B only tranzeo into a b/g tranzeo with 5/10/20 mhz channel widths.
Regards Michael Baird > Curious - on those older cards does it still listen at the default of 20 mhz > channels like the older Atheros cards? > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > "When you have eliminated the impossible, that which remains, however > improbable, must be the truth." > --- Sir Arthur Conan Doyle > > > On Fri, Aug 7, 2009 at 12:08 PM, Michael Baird <m...@tc3net.com> wrote: > > >> Thanks for that, the new firmware also enables 5/10 mhz channel widths >> on some of the older cards. >> >> Regards >> Michael Baird >> >>> John >>> Tranzeo released a new firmware update the other day that has helped >>> >> my >> >>> 900 system a lot. Better signal and much faster pings. I have been >>> >> fighting >> >>> the same problem as you for the past couple of months. >>> >>> Terry >>> >>> ----- Original Message ----- >>> From: "John Scrivner" <j...@scrivner.com> >>> To: "WISPA General List" <wireless@wispa.org> >>> Sent: Friday, August 07, 2009 7:45 AM >>> Subject: Re: [WISPA] Tranzeo 900 Latency >>> >>> >>> >>> >>>> Thanks for all these good tips. The items below are the things we have >>>> tried >>>> so far with no success. We are using smaller channels, H-pol. Filters >>>> >> have >> >>>> not helped the problem, noise floor is actually pretty good, C/I of >>>> >> about >> >>>> 20 >>>> on most CPE.. We are going to try the two setting changes that Daniel >>>> >> and >> >>>> Tom advised in other posts relating to beacon and RTS on clients. I will >>>> report our results. >>>> Thanks to all! >>>> Scriv >>>> >>>> >>>> On Thu, Aug 6, 2009 at 9:33 AM, 3-dB Networks <wi...@3-db.net> wrote: >>>> >>>> >>>> >>>>> What does your noise floor look like? C/I? >>>>> Have you tried moving from H-pol to V-pol and vice versa? >>>>> Could it be self interference (which I think might be the biggest >>>>> >> problem >> >>>>> with 900MHz, at least the possibility of it)? >>>>> What type of antennas are you using... can you sectorize further or put >>>>> higher gain antennas at the clients? >>>>> Can you add filters possibly to help with the noise? >>>>> How large are your channels? Can you use a smaller channel? >>>>> >>>>> Assuming your sectors are not overloaded... I would assume interference >>>>> too. >>>>> >>>>> Now I would pitch Canopy... but I'm sure you don't want to hear that >>>>> >> :-D >> >>>>> Daniel White >>>>> 3-dB Networks >>>>> http://www.3dbnetworks.com >>>>> >>>>> >>>>> >>>>> >>>>>> -----Original Message----- >>>>>> From: wireless-boun...@wispa.org [mailto:wireless-boun...@wispa.org] >>>>>> >> On >> >>>>>> Behalf Of John Scrivner >>>>>> Sent: Thursday, August 06, 2009 7:10 AM >>>>>> To: WISPA General List >>>>>> Subject: [WISPA] Tranzeo 900 Latency >>>>>> >>>>>> We have a couple of sectors of 900 MHz Tranzeo which were running fine >>>>>> previously but seem to experience enormous latency at times now. I am >>>>>> talking about upwards of 5000 milliseconds (5 full seconds) for a >>>>>> >> return >> >>>>>> on >>>>>> a ping. It is intermittent. I am guessing interference but was >>>>>> >> wondering >> >>>>>> if >>>>>> anyone had seen anything else cause this. We have had limited success >>>>>> >> in >> >>>>>> dealing with interference in 900 MHz previously so we are hoping there >>>>>> is >>>>>> something else we can try before completely bailing on the band in >>>>>> >> those >> >>>>>> locations. Any ideas are appreciated. >>>>>> John Scrivner >>>>>> >>>>>> >>>>>> >>>>>> >>> >>> >>> >> -------------------------------------------------------------------------------- >> >>> WISPA Wants You! Join today! >>> http://signup.wispa.org/ >>> >>> >> -------------------------------------------------------------------------------- >> >>> WISPA Wireless List: wireless@wispa.org >>> >>> Subscribe/Unsubscribe: >>> http://lists.wispa.org/mailman/listinfo/wireless >>> >>> Archives: http://lists.wispa.org/pipermail/wireless/ >>> >>> >> >> >> -------------------------------------------------------------------------------- >> WISPA Wants You! Join today! >> http://signup.wispa.org/ >> >> -------------------------------------------------------------------------------- >> >> WISPA Wireless List: wireless@wispa.org >> >> Subscribe/Unsubscribe: >> http://lists.wispa.org/mailman/listinfo/wireless >> >> Archives: http://lists.wispa.org/pipermail/wireless/ >> >> > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > -------------------------------------------------------------------------------- > > WISPA Wireless List: wireless@wispa.org > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/ > -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
