Your time is off and FT4 has pretty tight timing tolerances.The vast majority
of your DT values in your decodes should be < 0.5 seconds for best results.
If you're on Windows install Meinberg NTP and ensure you selection an
appropriate location in the pull down that shows up during installation.de Mike
W9MDB
hamspots.net will show you how others see you. There can be a significant
difference in receive and transmit DT values with some buggy setups.de Mike
W9MDB
On Wednesday, September 4, 2019, 05:01:12 AM CDT, Ken Chandler
<[email protected]> wrote:
Hi guys
I hope someone can make sense of this as I've completely lost all decode on FT4.
During WWDIGI my log contained 250 odd QSO's all bands, most of those were on
FT4.
On Monday 1st sept, I set up N1MM + WSJT-X for the RSGB trial FT4 contest on
80m.
I did some tests with a friend on the south coast and decoded ok with 100w.
However afterward others called in and I could not decode them.
During the RSGB trial FT4 contest (one hour duration) the waterfall was full of
stations.
I actually worked G4OGB early on but no other Stn was decoded though I could
see plenty were calling me on the waterfall.
I've reloaded 64bit software on an i7 Nuc, with Microham keyer, K3, with this
setup I've worked a few Thousand QSO's.
Please note
Running just WSJT-X and FT8 decodes great.
I tried this yesterday on 20m, switching to FT4 14080.00 lots of stn's active
....no decode!!!
Regards
Ken.. G0ORH
Sent from my iPad
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
_______________________________________________
wsjt-devel mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
