That fixes it.
If the subscriber uses a router, and it is on the DMZ, then that could
work (you get zero entries in the NAT table).
However, if they are bridging through to the SM, then it probably won't
be useable. A couple of Macs bridged will eat >1024 connections in no
time. A lot of Apple software has the nasty habit of never closing a
connection, so the NAT table fills up in no time.
bp
<part15sbs{at}gmail{dot}com>
On 7/15/2015 7:04 PM, Chitrang Srivastava wrote:
Hi Bill,
Please reduce the NAT table size from Configuration - >NAT, to 1024 and try it
out.
Thanks,
Chitrang Srivastava
Cambium Networks
________________________________________
From: Chitrang Srivastava
Sent: 15 July 2015 07:38:49
To: af@afmug.com
Subject: Re: [AFMUG] Software 13.4: P8 FSK not recommended
Hi Bill,
In order to investigate P8 issue, please do following,
AFTER upgrade to P8 and applying configuration changes but BEFORE doing reboot,
take out engineering.cgi.
Please also send configuration file as well from Configuration - > Unit Setting.
Does without NAT P8 is accessible?
If the above steps didn't work ( actually they should because most of our
configuration changes applies on next reboot) they please send screen shot of
NAT configuration page before you press Save Changes.
Thanks,
Chitrang Srivastava
Cambium Networks
________________________________________
From: Af <af-boun...@afmug.com> on behalf of Bill Prince <part15...@gmail.com>
Sent: 15 July 2015 05:35:23
To: af@afmug.com
Subject: Re: [AFMUG] Software 13.4: P8 FSK not recommended
Nope. Have already loaded 13.4 on P9, P10, and P11, and all is good with
them.
Have also loaded 13.4 on PMP430 and PMP450.
bp
<part15sbs{at}gmail{dot}com>
On 7/14/2015 4:59 PM, George Skorup wrote:
I wonder if this affects P9 boards as well? That would suck. Not sure
if I have one around the office to test.