I would be very suspicious if ANYTHING can transmit at 256qam 3/4 or 5/6 at
+30. +24 is nice. When it was first announced I was expecting +20 or +19
for link budget calculation.

On Jul 29, 2016 11:20 AM, "Christopher Gray" <[email protected]>
wrote:

> I've had an open ticket about the AF-2X for over a month. I have not been
> able to actually work with anyone on the issue. It has been "escalated" but
> without any positive results.
>
> Is there a better way to talk to someone about the airFiber?
>
> The spec sheet says a US AF-2X has a maximum Tx power of 30 dBm... but it
> only goes up to 24 dBm. [I'm running an 18 dBi dish on one end with long
> cables, and I need the additional 3 dB Tx power). When changing channel
> width, the Rx power does not change (Rx power is usually measured in
> dBm/20Hz on most UBNT hardware, so power usually goes up 3 dB when halving
> the bandwidth, but I can't get a straight answer as to whether they use the
> same units on the AF line).
>
> Long story short, I'm going to have to get rid of this AF-2X hardware and
> switch back to ePMP. The AF-2X would be the better choice if I could get
> the power levels I need to make this link work. I would much rather solve
> the AF problems..
>
> -Chris
>
>

Reply via email to