Matt,

Thank you for checking on it. I just emailed Chuck. I imagine it can be
difficult to find the support claims that are legitimate / useful, so I'm
not faulting anyone.. I'm just looking to get through to the right people.

I'm excited about the link. I look forward to getting it sorted out.

-Chris

On Fri, Jul 29, 2016 at 5:15 PM, Matt Hardy <[email protected]> wrote:

> Hey Chris,
> Sorry about this. I'll check with the team and see why you haven't been
> able to get in touch with anyone...
>
> We'll follow up shortly.
>
> Thanks,
> Matt
>
> On Fri, Jul 29, 2016 at 2:20 PM, Christopher Gray <
> [email protected]> wrote:
>
>> I've had an open ticket about the AF-2X for over a month. I have not been
>> able to actually work with anyone on the issue. It has been "escalated" but
>> without any positive results.
>>
>> Is there a better way to talk to someone about the airFiber?
>>
>> The spec sheet says a US AF-2X has a maximum Tx power of 30 dBm... but it
>> only goes up to 24 dBm. [I'm running an 18 dBi dish on one end with long
>> cables, and I need the additional 3 dB Tx power). When changing channel
>> width, the Rx power does not change (Rx power is usually measured in
>> dBm/20Hz on most UBNT hardware, so power usually goes up 3 dB when halving
>> the bandwidth, but I can't get a straight answer as to whether they use the
>> same units on the AF line).
>>
>> Long story short, I'm going to have to get rid of this AF-2X hardware and
>> switch back to ePMP. The AF-2X would be the better choice if I could get
>> the power levels I need to make this link work. I would much rather solve
>> the AF problems..
>>
>> -Chris
>>
>>
>

Reply via email to