We have one working pretty good.... From bank to water tank as backhaul
where Vivint and Mexus are hogging 5GHz...fed by AF 24HD.

On Jul 29, 2016 5:19 PM, "Christopher Gray" <[email protected]>
wrote:

> Exactly. FCC area using US model AF-2X. Cable loss approx 1 dB, so power
> conducted to the antenna is 1 dB less than power from the radio, so I'm
> expecting 27 dBm out of the radio.
>
> I'm in the 4X modulation range. Data sheet states max suggested Tx for 4X
> is 27-28 dBm. The radios simply don't allow more than 24 dBm (at any
> modulation) with the current firmware. It looks like this will be resolved
> soon, which is awesome.
>
>
>
> On Fri, Jul 29, 2016 at 3:27 PM, Ken Hohhof <[email protected]> wrote:
>
>> Is this in FCC area?  FCC rules for 2.4 GHz PTP are 30 dBm max
>> transmitter power with 6 dBi antenna, for a total +36 dBm EIRP.  Then for
>> antenna gain above 6 dBi, you have to reduce xmt power 1 dB for every
>> additional 3 dB of antenna gain.  Also this is independent of channel
>> width, it’s not dBm/MHz.
>>
>> So you have an 18 dBi dish, that’s 12 dBi of additional antenna gain, so
>> you would have to reduce xmt power by 1/3 of 12 dBi or 4 dB, to +26 dBm,
>> and max EIRP would be +42 dBm.
>>
>> How many dB do you figure you’re losing in the long cables?  I’m unclear
>> on whether cable loss counts against xmt power or antenna gain.  If you’re
>> losing several dB in the cable, I can see where you’d want the full +30 dBm
>> xmt power from the radio.
>>
>> *From:* Christopher Gray <[email protected]>
>> *Sent:* Friday, July 29, 2016 1:20 PM
>> *To:* [email protected]
>> *Subject:* [AFMUG] UBNT AF-2X Problems... Where Do You Go For Help?
>>
>> I've had an open ticket about the AF-2X for over a month. I have not been
>> able to actually work with anyone on the issue. It has been "escalated" but
>> without any positive results.
>>
>> Is there a better way to talk to someone about the airFiber?
>>
>> The spec sheet says a US AF-2X has a maximum Tx power of 30 dBm... but it
>> only goes up to 24 dBm. [I'm running an 18 dBi dish on one end with long
>> cables, and I need the additional 3 dB Tx power). When changing channel
>> width, the Rx power does not change (Rx power is usually measured in
>> dBm/20Hz on most UBNT hardware, so power usually goes up 3 dB when halving
>> the bandwidth, but I can't get a straight answer as to whether they use the
>> same units on the AF line).
>>
>> Long story short, I'm going to have to get rid of this AF-2X hardware and
>> switch back to ePMP. The AF-2X would be the better choice if I could get
>> the power levels I need to make this link work. I would much rather solve
>> the AF problems..
>>
>> -Chris
>>
>>
>
>

Reply via email to